EASY POINTING
They facilitate grouting
EASY POINTING is a pre-grouting impregnation agent that facilitates the removal of grout residues.
Its use greatly facilitates the removal of grout residues from treated surfaces after grouting. It can also be used to wipe off grout residues with a wet sponge.
It facilitates the removal of grout residues from:
- paving tiles
- bricks
- natural stone
- clinker surfaces.
You can order here:
Storage:
EASY POINTING can be stored in iron, plastic or glass containers. Zinc-coated aluminum or galvanized containers are not suitable for storage. In a closed container, EASY POINTING can be stored for two years (24 months) from the date indicated on the label.
The product must always be stored above 0 C C.
If the material crystallizes due to too low a temperature, it will dissolve again when heated. Then the product must be stirred well. If the product's shelf life has expired, the material may still be good, which must be confirmed by a preliminary test.
Application:
EASY POINTING should be used without dilution.
It is advisable to apply the product to the surface with a teddy roller or brush before grouting. Make sure that the material does not flow into the joint. Soak the surface well with the material in one layer.
After treatment, be sure to wait 2-3 hours before starting grouting (in cool, humid weather, the waiting time is 4-5 hours)!
The treated surface can even be grouted completely. After grouting, wipe the surface with a wet sponge. This may need to be repeated several times, depending on the surface.
If necessary, the washed surface can be further cleaned with CEMENT DIRT REMOVER.
After the joint and surface have completely dried, impregnate it with one of the products. Attention! STONE PROTECTOR cannot be used after using the Jointing Easing Agent!
Attention: The surface to be treated must not be overheated! You can use it on a monument or a monument-like building only at your own risk.
Treatment temperature: 10-30 oC.
Always perform a test treatment on the surface to be treated. This way, you can calculate, for example, the desired amount of material.
Coverage:
For the treatment of 1 m2of brick surface or well-absorbing natural stone surface, 0.25-0.5 liters is sufficient.
For clinker surfaces, the material requirement per 1 m2 is 0.1-0.2 liters.
In the case of very porous natural stone (e.g. tuff) or broken bricks, the material requirement can reach 0.5-0.75 liters.
Safety measures:
EASY POINTING is an alkaline and corrosive substance. When handling the product, wear rubber gloves and safety glasses!
In case of splashes on the skin, wash it off with plenty of water. If the product gets into the eyes, wash it off immediately with plenty of water and call a doctor due to its caustic and corrosive effects. Clothing soaked in EASY POINTING must be removed immediately.
For more detailed instructions, please refer to the "Safety Data Sheet", which can be obtained from the manufacturer or the dealer.
Safety Data Sheet reach
|
|