CEMENT DIRT REMOVER
CEMENT DIRT REMOVER easily removes cement traces, cement veil, mortar residues from the surface of acid-resistant building materials (e.g. acid-resistant natural stones, clinker bricks, ceramics). It effectively removes rust and limescale deposits from the surface.
Warning: Do not use on limestone, marble, chrome-plated or other non-acid-resistant surfaces!
Always test the product on a less visible area before application!
After successful treatment, depending on the surface, it is recommended to impregnate the clea-ned surface with one of our AQUA-STOP W products (e.g. UNIVERSAL).
You can order here:
Storage:
Store in a dry, cool, well-ventilated place, away from direct sunlight. Keep away from incompatible materials (oxidizing agents, alkalis, cyanides, sulfides, formaldehyde), heat, and sources of ignition. Shelf life is unlimited.
Application:
Slightly moisten the surface to be cleaned, then apply CEMENT DIRT REMOVER undiluted or diluted with water in a ratio of max. 1:5 with a brush or sponge.
Let the product work on the surface for a few minutes, then scrub the surface with a brush.
Repeat the procedure if necessary. Make sure that the product does not dry on the surface.
Rinse the cleaned surface with plenty of water.
Always check the compatibility of the product with the surface to be treated in a hidden place before use!
Do not clean acid-sensitive surfaces with it. Do not use it to clean aluminum, anodized aluminum, marble, enamel, limestone!
Use rubber gloves and safety glasses during work!
Warning: You can use it on a listed building or a building of a listed building only at your own risk.
Caution: The surface to be treated must not be overheated!
Treatment temperature: 10-30 oC.
Safety measures:
Use rubber gloves and safety glasses during work!
The "Safety Data Sheet" can be obtained from the manufacturer or the dealer.
You can order here:
Safety Data Sheet reach
|
|