WALL SAND-LIME BRICK PROTECTOR Professional
Lime-sand brick impregnation for exteriors
WALL SAND-LIME BRICK PROTECTOR Professional has been specially developed for outdoor sand-lime brick surfaces that are very sensitive to water and dirt.
Using it, we can prevent the surface from becoming dirty, waterlogged, algae-forming, nitrate-forming, salt efflorescence and winter freezing.
After treatment, the surface no longer absorbs water after 24-48 hours, it repels it.
Attention: We cannot replace bad or damaged insulation with treatment, we can only reduce the damage at most!
The solution is to use good insulation and impregnation together.
You can order here: 
Storage:
WALL SAND-LIME BRICK PROTECTOR PROFESSIONAL can be stored in its original, closed container at 0-30 oC for at least 24 months from the date indicated on the label. However, experience has shown that it can be stored for up to 3 years without deterioration in quality.
During storage, surface creaming may occur, but this is not an irreversible process, i.e. after brief shaking or mixing, a homogeneous substance with unchanged properties is obtained again.
WALL SAND-LIME BRICK PROTECTOR PROFESSIONAL contains a small amount of preservative against microorganisms and fungi.
Application:
If the brick is placed in mortar or other binding material, treat the surface together with the joint after it has dried and set.
It is recommended to apply WALL SAND-LIME BRICK PROTECTOR PROFESSIONAL to the surface to be treated in two layers by pouring or by large-drop spraying (the material should flow onto the surface). The second layer must always be applied before the first layer has dried ("wet-on-wet" method)!
The material requirement for the two-layer treatment of 1 m2 of sand-lime brick surface is 0.4-0.9 liters per square meter. The practical average: 0.6 liters/m2
Always carry out a test treatment on the surface to be treated!
This way we can calculate and check, for example, the desired amount of material or the effectiveness of the agent.
With WALL SAND-LIME BRICK PROTECTOR PROFESSIONAL, due to its special composition, the surface can be re-treated at any time.
Attention: The surface to be treated must not be overheated!
Treatment temperature: 10-30 oC.
Safety measures:
The "Safety Data Sheet" can be obtained from the manufacturer or the dealer.
Safety Data Sheet reach
|
|