WALL PROTECTOR
Plaster impregnating agent
WALL PROTECTOR
Plaster impregnating agent
WALL PROTECTOR is recommended for painted or unpainted, raw plastered surfaces with mineral-based wall paint.
After treatment, the plaster does not absorb water after 24-48 hours, it repels it.
By using it, we can prevent nitrate formation, salt efflorescence, and winter freezing.
Attention: We cannot replace bad or damaged insulation with treatment, we can only reduce the damage! The solution is to use good insulation and impregnation together.
Can only be applied to a dry surface!
Storage:
WALL PROTECTOR can be stored in its original, closed container at 0-30 oC for at least 24 months from the date indicated on the label. However, experience has shown that it can be stored for up to 3 years without deterioration in quality.
During storage, surface creaming may occur, but this is not an irreversible process, i.e. after brief shaking or mixing, a homogeneous substance with unchanged properties is obtained again.
WALL PROTECTOR contains a small amount of preservative against microorganisms and fungi.
Application:
It is recommended to apply the WALL PROTECTOR to the surface to be treated in two layers by pouring or by spraying with large drops (the material should flow on the surface). The second layer must always be applied before the first layer dries ("wet-on-wet" method)!
The material requirement for a two-layer treatment of 1 m2 is 0.4-0.9 liters per square meter. The practical average: 0.5 liters/m2.
Always carry out a test treatment on the surface to be treated! This way we can calculate the desired amount of material and the effectiveness of the agent.
Since the WALL PROTECTOR contains a wetting agent, any subsequent treatment can be carried out without any further difficulties.
Attention: You can use it on a listed building or a building of a listed building only at your own risk.
Caution: The surface to be treated must not be overheated!
Treatment temperature: 10-30 oC.
Safety measures:
The "Safety Data Sheet" can be obtained from the manufacturer or the dealer.
Safety Data Sheet reach
|
|