GRILL PROTECTOR
Grill impregnating agent
GRILL PROTECTOR is designed to protect grills made of stone, artificial stone or concrete.
Freshly spilled grease and oil can be easily wiped off with a cloth, and more stubborn dirt can be removed with hot water or a high-pressure washer with hot water.
The treated grill becomes oil and water repellent, which makes it easier to clean and also protects against frost damage.
If the water and oil repellent ability of the surface decreases due to frequent cleaning, repeat the treatment.
You can order he:
Storage:
GRILL PROTECTOR can be stored in its original, closed container at temperatures between 0 and 30 oC for at least 24 months from the date indicated on the label. If the product's shelf life has expired, the material may still be good, which must be confirmed by a preliminary test.
After opening, the material must be stored hermetically sealed, as the material reacts with the humidity of the air.
Application:
GRILL PROTECTOR should be used undiluted. It is recommended to apply it to the surface to be treated with a brush or spray. If necessary, apply in 2 layers. The surface to be treated must be dry to the touch!
Coverage:
1 liter of material is sufficient for treating 15-20 m2 of stone surface, with one layer. In the case of very porous, porous stones, the material requirement may reach 0.2-0.5 liters/ m2. When calculating the required amount of material, it must be taken into account that the material must always be applied in two layers!
Always carry out a test treatment on the surface to be treated. This way, you can calculate, for example, the desired amount of material or the effectiveness of the agent, and thus avoid possible discoloration. The water and oil repellent effect develops after 24 - 48 hours.
Dirt should be removed from the surface to be treated as thoroughly as possible, especially paint, because it is very difficult to remove after the protective layer has been applied.
Removing dirt: Everyday dirt can be removed with a neutral pH detergent, by hand or machine washing. Surfaces contaminated with oil or other stubborn dirt can be cleaned with hot water or steam.
Attention: The agent must NOT be sprayed (it must be sprinkled)!
Caution: The surface to be treated must not be overheated!
Treatment temperature: 10-30 oC.
Safety measures:
Use rubber gloves and safety glasses during work!
The "Safety Data Sheet" can be obtained from the manufacturer or the dealer.
Safety Data Sheet reach
|
|