SILICONE PROTECTION Kft.
Hungarian silicone surface protection • 2768 Újszilvás
Animal Life • surface protection for animal facilities
Kennel Protector – Animal Life
Typical problems we help solve:
- efflorescence, salt blooms and crumbling render
- damp, mouldy walls and mossy roofs
- dirty paving, oil and rust stains
- invisible protection for heritage façades
“Let Hungarian heritage be protected by Hungarian products!”
What is it for?
Kennel Protector – Animal Life is ideal for treating concrete, stone, brick and rendered surfaces in animal facilities (kennels, pens, stables, etc.).
Less absorption
Easier cleaning
Less odour
Water repellency in 24–48 hours
Using it helps prevent urine from soaking into the surface, reduces odour formation, limits render flaking caused by frequent washing, and makes waste removal easier.
Application
1) Application
Apply by pouring or large-droplet spraying (let the product run over the surface), in two coats.
2) Wet-on-wet
Always apply the second coat before the first coat has dried.
3) Coverage
For two coats, depending on the absorbency of the surface: 0.3–1.0 square metres per litre.
4) Test area
Always carry out a small test to confirm the required amount and the effectiveness.
Warning: The surface must not be overheated. Application temperature: 10–30 degrees Celsius.
Caution: For listed or heritage-type buildings, use only at your own responsibility.
Caution: For listed or heritage-type buildings, use only at your own responsibility.
Storage and safety
Storage: in the original, closed container, between 0 and 30 degrees Celsius, it keeps for at least 24 months. In practice, it can be stored for up to 3 years without quality loss.
During storage, a light surface creaming may occur; after brief shaking or stirring the product becomes homogeneous again.
Contains a small amount of preservative to protect against microorganisms and fungi.
The Safety Data Sheet can be obtained from the manufacturer or the distributor.
Independent expert report (bioactive effect)
English translation (for narration):
Expert opinion
On the bioactive effect of AQUA‑STOP W ANIMAL LIFE
AQUA‑STOP W ANIMAL LIFE is an aqueous emulsion of alkyl‑alkoxysilane and siloxane. The material has a pH value of 7.
After application to the surface, within 12–24 hours the product chemically bonds to the substrate, providing very stable, water‑repellent protection. Therefore, once applied and dried, the AQUA‑STOP W ANIMAL LIFE layer is a biocompatible product without toxic or other negative effects.
Based on the above, the product is suitable for surface treatment of animal living areas; the silicone rubber formed on the surface is not harmful to living organisms.
Prepared by: Dr Professor József Nagy, Doctor of Sciences, retired university professor, silicone expert.
(The Hungarian original is authoritative.)
Expert opinion
On the bioactive effect of AQUA‑STOP W ANIMAL LIFE
AQUA‑STOP W ANIMAL LIFE is an aqueous emulsion of alkyl‑alkoxysilane and siloxane. The material has a pH value of 7.
After application to the surface, within 12–24 hours the product chemically bonds to the substrate, providing very stable, water‑repellent protection. Therefore, once applied and dried, the AQUA‑STOP W ANIMAL LIFE layer is a biocompatible product without toxic or other negative effects.
Based on the above, the product is suitable for surface treatment of animal living areas; the silicone rubber formed on the surface is not harmful to living organisms.
Prepared by: Dr Professor József Nagy, Doctor of Sciences, retired university professor, silicone expert.
(The Hungarian original is authoritative.)